Capacitive auto-height regulator
Capacitive height adjusting controller Technical parameter:
Input power: 24VAC
Elevating motor: 24VDC, permanent-magnet DC motor, Max. 5A
Working temperature: Height adjustor0-60º C, high frequency wire: 0-200º C
Inspection/distance precision: 2-30mm. Suggestion distance: ± 10+0.1mm
Installation requirement: Full seal, set up at the place which has good air convection
Size/ weight: 175× 80× 58mm, 0.9KG
Protection degree: IP64, prevent the dust get into
Installation connector: DIN43652 standard, 8pin
Lifting mechanism: Use low clearance screw mandrel and gear box, the speed reduce ratio of gear box should calculate according to the max speed 3000mm/min of lifting mechanism. The lifting mechanism (prepared by user) should as light as possible and the motor can not overload.
|Nozzle hole dia.||Recommend plate thickness||Recommend cutting Amp||Recommend cutting speed||Note|
|1.1|| 0.5~ 2MM|| 20~30A|| ~2600||This configuration parameters are test results of models with 65% loading rate.|
For every drop of 10% loading rate, it would need to increase 10% cutting current in accordance with the table.
This configuration table suggests current air pressure of 0.45 MPa, and the torch is Black Wolf P80 torch, 10 meters wire, different torch and different lengths wire correspond to adjusting air pressure. The longer the wire is, the higher air pressure is.
|1.3|| 2~5MM|| 30 ~50A|| ~2000|
|1.5|| 5~8MM|| 50~70A|| 1200~ 1500|
|1.7|| 8~12MM|| 70~90A|| 800~1200|
|2.0|| Above 12MM|| Above 90A||Below 800|